Fast 30400-KIT-EZ-EF, Инструкция по эксплуатации

Страница: 10 / 70

10
In-tank Fuel Pump System Installation:
1. Begin by dropping your fuel tank and removing your fuel sending unit module. Be sure to
clean the area around the sending unit before removal and be sure that no debris enters the tank
while you are working on it.
2. With the sending unit out, remove the old fuel pump and replace with your new pump. Two
40-60mm hose clamps are included with the FAST™ in-tank fuel kits to order to mount the
pump. A sock-type pre-filter is also provided and should be connected to the bottom of the
pump. Connect the pump to a tank outlet being sure to use the submersible-rated hose. If an
outlet is not available, a bulkhead fitting has been included with the fuel kit to provide for one.
If using the bulkhead fitting, be sure to use the provided nylon washers on either side of the
hole.
3. Wire the pump using the included pigtail and feed the wires out of the tank using the supplied
two-wire sealed bulkhead fitting.
4. With the fuel pump module complete and reinstalled in the tank, now run the rest of the system
as shown in the layout on the following page.
5. If running a returnless-style fuel system, plug off one of the ports on the throttle body (either
port can be used as the inlet and the other will be plugged.) You will not need to install the fuel
pressure regulator or the return line to the fuel tank.