Faro FaroArm Fusion, Руководство пользователя

Страница: 86 / 130

FaroArm ® Manual
January 2009
78
Chapter 2: CAM2® Measure Devices Menu
Edit Probe
Click the EDIT button in the P
ROBES
dialog box to modify the details of
the current probe. Change any settings and click the MODIFY button to
continue.
To create a new probe:
1 Enter a new Name for the probe.
2 Enter the diameter of the probe. Check the status bar at the bottom
of your screen for the current units.
3 Select the A
UXILIARY
S
WITCH
check box, and enter a De-bounce
Time if necessary.
4 Select the G
UIDANCE
check box to use the guidance feature in
single hole calibration. See “Single Hole Method - Guidance” on
page 80 , and “Single Hole Method” on page 83 .
5 Click the CREATE NEW button.
The new probe is now current. You must calibrate the new probe.
Probe Calibration Overview
Probe calibration is a localized process by which a measurement device
is optimized to perform measurements accurately.
To understand probe calibration, you must first understand the
FaroArm's reference system. The FaroArm is factory calibrated from
the base to the last joint or axis, and the position of this joint is defined
by the coordinate system which originates at the base of the FaroArm.
The last axis of the FaroArm has its own coordinate system, and the
location of the center of the ball probe is reported in the probe's
Figure 2-4 Modify Probe Dialog Box
08M46E00_FaroArmUSB.book Page 78 Tuesday, February 17, 2009 1:42 PM