22
22
111628E
Revision date: 02.16.23
2
Assembly Instructions
Required parts:
• 111030 End Cap (plain)
• 9/32" Drill Bit and Drill
ASSEMBLE ALL 12' FODDER CHANNELS: 111582
Complete these steps to prepare the 111030 end caps:
1. Gently clamp the 111030 end cap in a vice or
similar device with the top, rounded edge up.
2. Locate the middle of the end cap lip and mark
the position using a pencil.
NOTE:
Center mark on top lip is shown.
3. Using a drill and a 9/32" bit, carefully drill a
hole in the top lip of the 111030 end cap.
4. Remove the loose end cap material from the
drilled hole.
5. Repeat the steps to drill a hole in center of all
remaining 111030 end caps.
Do not drill the
111029 end caps.
ATTENTION:
Complete this procedure for the 111030
plain end caps only.
Do not drill holes in the 111029
end caps, which have an outlet.
111029 End Cap
Top Edge of End Cap
ATTENTION:
Cover the
vice jaws or use material
to protect the end cap.
Rounded
Tab at
the Top
111030 End Cap
