POLY BUILDINGS
24
Revision date: 03.15.12
END PANEL INSTALLATION (continued)
Secure the End Panel to the End Frame
The frame shown in the following diagrams may differ from
the actual frame. Installation steps are the same.
1. With door opening cut, secure the end panel to the
door frame using Tek screws and washers. See
diagram below.
NOTE:
For the exposed corners of the door frame
that remain, cut a piece of material
from the
scrap end
panel material
to cover the exposed frame and secure
the piece to the corners using Tek screws and washers
(if desired).
ATTENTION:
DO NOT secure the end panel to the
inside or backside of the door jambs
. Some doors kits
use this surface for tracks and brackets. Check the
instructions that shipped with the door for additional
details.
2. Continue with the installation of the pedestrian door.
Secure the end
panel to the inside
surface of the
frame tube using
a Tek screw and
washer.
Door Frame
Inside
surface of
End Panel
Install Tek
screw here
Inside View
Sample frame is shown in the diagram. Actual frame may differ.
PEDESTRIAN DOOR INSTALLATION
The pedestrian door is installed between the vertical
door frame members of the end wall. The following steps
describe one way to install the door.
1. Using the previous instructions, cut the panel from the
opening for the pedestrian door.
2.
Wrap the end panel flap around the long door jamb of
the frame and secure on the back, inside surface using
Tek screws and washers.
Door
Jamb
Inside
surface of
End Panel
Install Tek
screws
along this
surface.
NOTE:
Do not attach the panel flap to the header or
short door jamb of the pedestrian door frame at this
time.
Remove the
shaded section
as instructed.
Do not attach the panel to these
door frame members until the
door is installed.
View from the outside.
