17
POLY BUILDINGS
Revision date: 03.15.12
ATTACH ROLL-UP CRANK
ASSEMBLY
A hand crank is used to raise and lower the zippered fabric
roll-up door of the end panel. Install the roll-up components
following the procedures below.
NOTE:
Assure the door rolls inward so rain water does not
collect inside the door when rolled up.
Required parts:
• Universal joint (#103396)
• Crank handle (#103395)
• Swaged pipe (#131S075)
• Plain pipe (#131P0735)
• Fabric Clips (#CC6212): Quantity—5
• Tek screws (#FA4482B)
1. Select a (#131P0735) 73.5" plain pipe and a
(#131S075) 75" swaged pipe.
2. Assemble a crank extension by sliding the swaged end
of a 75" pipe into the plain end of a 73.5" pipe. Secure
the pipe joint using a Tek screw.
3. Slide the crank handle (#103395) into one end of the
extension and the universal joint (#103396) into the
other end. Use a Tek screw to secure each component
to the crank extension.
7. Secure the conduit to the roll-up door using fabric clips
(CC6212) and Tek screws. Evenly space the fabric
clips as shown. Diagram shows a similar door. Actual
clip quantity may differ from what is shown.
8. Attach the universal joint to the exposed end of the roll-
up conduit using a Tek screw.
Fabric Clips
and Tek Screws
Crank Handle
Universal Joint
4. Assemble a roll-up door conduit by sliding the swaged
end of a 75" pipe into the plain end of a 73.5" pipe.
Secure the pipe joint using a Tek screw.
5. Wrap two layers of duct tape over the pipe joint and Tek
screw head.
6. Insert the roll-up door conduit into the pocket in the
bottom of the door. Leave 3-4" of conduit extend out of
the pocket where you want to attach the roll-up crank.
NOTE:
If the roll-up door conduit is too long and
extends past the door pocket on both ends, cut the
conduit as required so it is 3-4" longer than the door
width. Remove any burrs from the cut end.
Roll-up Conduit
Universal
Joint
9. Test the roll-up door assembly and make any
adjustments needed.
10. Continue with Front End Framing Assembly
instructions.
