Fargo HDP100, Руководство пользователя

Страница: 44 / 121

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
3
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
CARD JAM:
TRANS A card is jammed in the
Transfer Station of the
Printer. See the Resolving the Card Jam
Error procedure.
CARD NOT
FOUND The card being
processed cannot be
found. Press RESUME to load the next
card or CANCEL. See
Resolving
a Card Not Fed Error .
MULTIPLE FEED Two or more cards may
have been fed from the
Card Hopper. If so, remove the fed cards and
verify the card thickness setting is
set to the thickness of your cards.
See
Resolving a Card Not Fed
Error (Cards will not feed off the
Hopper)
.
Press RESUME to continue.
Clean Printer For best Printer
performance, replace the
Cleaning Cartridge Tape
and clean the Printers
Feed Rollers and
Printhead at this time. See Cleaning .
E-Card Encoder
Startup Error A problem was detected
during Printer start-up. If this problem persists, call for
technical assistance. See
E-card
Encoding Errors .
E-CARD STARTUP
ERROR A problem was detected
during Printer start-up. If this problem persists, call for
technical assistance. See
E-card
Encoding Errors .
EEPROM
CORRUPT EEPROM restored with
factory default values. No action needs to be taken.
EJECTING Indicates cards are
ejecting. No action needs to be taken.
EJECTING CARD The system Firmware
has detected a card
already in the Printer and
is ejecting it. This card has been ejected;
however, it may contain encoded
data and therefore should be
disposed of properly.
Continued on the next page