Fantic Motor INTEGRA 140 TRAIL, Руководство пользователя и по обслуживанию

Страница: 64 / 94

06
6-4
Ed. 1 - 11/2017
Using power assisted pedalling
- Connect the power cable to the electrical
mains socket.
Make sure that the electrical mains supply
voltage corresponds to the value indicated
on the battery charger data plate.
- Connect the small plug on the power cable to
the socket on the battery charger.
- Connect the charger connector to the socket
on the battery pack.
- At this point the battery starts to recharge.
- The LEDs on the battery pack light up to indicate the charge level. When all four LEDs are lit it indicates
that the battery pack is fully charged.
Each LED corresponds to approx. 25% of the full charge.
- Disconnect the battery charger from its power supply and the connector from the battery pack.
- Once the battery pack has been fully charged, if it remains connected to the battery charger, and the
latter remains connected to its power supply, after two hours, the battery charger re-checks the state of
the battery and, if necessary, starts to recharge it again.
- The LEDs on the battery charger indicate its
current state (see table on the right).
4. MOUNTING THE BATTERY PACK ON ITS SUPPORT
- Insert the battery pack in its specific support
on the chassis by placing the rubber rod (1) on
the fork support (2).
LED
Stand-by green
Charging
red
Battery charged
green
Error
blinking red