Fantic Motor INTEGRA 140 TRAIL, Руководство пользователя и по обслуживанию

Страница: 34 / 94

03
3-6
Ed. 1 - 11/2017
Checks and inspections
3.h - Checking the brakes
Heavy fall hazard Faulty brakes
can always result in hazardous
riding conditions, falls and acci-
dents. A brake malfunction may
endanger the life of the rider.
- Take great care when checking you braking
system.
If you observe any defects, or in case of doubt,
do not use your bicycle, and contact the ven-
dor or a qualified technician
- While stationary, squeeze both brake levers as
far as they will go. The minimum distance be-
tween the brake lever and the handlebar grip
must be at least 10 mm.
Attempt to move the bicycle forwards or back-
wards; both wheels must remain blocked.
- Using your hands, pull the brake callipers in
every direction. It should not be possible to
move the brake callipers
Ensure that the brake disks are kept clean at all
times.
The presence of oil and/or grease
on the brake disks may reduce
braking efficiency resulting in
hazardous riding conditions,
falls and accidents.
- While stationary, operate the brake lever re-
peatedly, holding it in the operated position.
The compression point should not change.
- Visually inspect the braking system, starting
with the lever and checking the cables and
brakes. Make sure there are no hydraulic fluid
leaks.
- Check the brake disk for signs of damage. It
should be free from notches, breakages, deep
scratches and other mechanical damage.
- Raise the front wheel, followed by the rear
wheel, and rotate them by hand. The brake disk
must rotate freely.
MIN 10 mm