Fantech FQ80 Скачать руководство пользователя страница 1

FQ Series
Quiet Exhaust Fans  
and Fan-Lights

1.  Use this unit in the manner intended by the manufacturer. If you have 

any questions, please contact the manufacturer .

2.  Before servicing or cleaning unit, switch power off at service panel 

and lock the service disconnecting means to prevent power from 
being switched on accidentally. When the service disconnecting 
means cannot be locked, securely fasten a prominent warning 
device, such as a tag, to the service panel.

3.  Installation work and electrical wiring must be done by qualified 

person(s) in accordance with all applicable codes and standards, 
including fire-rated construction.

4.  Sufficient air is needed for proper combustion and exhausting of 

gases through the flue (chimney) of fuel burning equipment to pre-
vent back drafting. Follow the heating equipment manufacturer’s 
guideline and safety standards such as those published by the 
National Fire Protection Association (NFPA), and the American 
Society for Heating, Refrigeration and Air Conditioning Engineers 
(ASHRAE), and the local code authorities.

5.  When cutting or drilling into wall or ceiling, do not damage electrical 

wiring and other hidden utilities.

6.  Ducted fans must always be vented to the outdoors.
7.  If this unit is to be installed over a tub or shower, it must be marked 

as appropriate for the application and be connected to a GFCI 
(Ground Fault Circuit Interrupter) – protected branch circuit.

8.  NEVER place a switch where it can be reached from a tub or shower.
9.  This fan must be properly grounded.
10.  Do not use in the cooking area (Figure. 1).

Floor

Cooking 

Equipment

Cooking area

Do not install above 

or inside this area

45

45

Figure 1

11.  Do not block the air intakes or exhaust.
12.  Power supply wiring is to be No. 14 AWG wire or larger (suitable 

for at least 90°C (190°F) ).

13.  Not for use outdoors.
14.  For lighted units, use only CFL type T4, 26W lamp and a maxi-

mum 4 W night light .

15.  The fan must not be installed in a ceiling with an “R” rating 

greater than 40.

16.  The fan is type IC (Inherently Protected).
17.  To reduce the risk of injury, install the fan at least 7 feet (2.1m) 

above the floor.

18.  Acceptable for use over a shower or tub when installed in a GFCI 

protected branch circuit.

19.  The fan should not be turned on or off rapidly.
20.  Do not clean the fan with corrosive chemicals or water in excess of 

60° C (140° F).

21.  If the fan is not operating properly, shut the power off immediately, 

and have a certified installer inspect it and have it serviced as 
required.

22.  These fan must be mounted to structural members that are strong 

enough to support the fan’s weight.

23.  Do not allow foreign objects to enter the fan; this could result in 

electric shock or fan damage.

READ AND SAVE THESE INSTRUCTIONS!

Read carefully all instructions before installing or using this product 

FQ Series Fan

FQ Series Fan-Lights

Package Includes:

1  Fantech Exhaust Fan or Fan-Light
5  Mounting Brackets
8  Mounting screws
1  26W CFL Type T4 (Fan-Light models only)
1  4w night light (Fan-Light Models only)

WARNINGS:

  BEFORE INSTALLATION, TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

CAUTION

:  

1.  For general ventilating use only. Do not use to exhaust haz-

ardous or explosive materials and vapors.

2.  This product is designed for installation in flat ceilings only. 

Do not install it in a sloping ceiling or in a wall.

3.  To avoid motor bearing damage and noisy unbalanced impel-

lers keep construction material / dust from entering the fan.

4.  Please read specification label on the product for further 

information and requirements.

Содержание FQ80













Отзывы: