20
FRX100 VA S Housing Instruction Manual 20220601
2.
Hold the camera parallel to the housing and then gently install it inside (image #12). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
3.
Take special care not to touch or damage the Vacuum System signal board when installing the
camera. The board is located inside the housing on the inner right side of the housing,
opposite the latch dial (image #13).
4.
If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera, in the slot midway up between the two rubber shock absorber
mounts, where it doesn’t interfere with proper housing operation. It is important to make sure
Image #12
Image #13
SIGNAL BOARD
