19
FRX100 VA S Housing Instruction Manual 20220601
7.
Finally, re‐install the black rubber disc at the end of the control by pushing it against the shaft
until it is fully and securely seated. Do so by mounting the 2 holes on the disc center onto the 2
protruding points at the end of the black plastic 2‐pointed seat.
8.
Once complete, install the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button.
9.
The C‐shaped washer should remain in this position as long as the housing is used to
accommodate the RX100 III camera. In case of using the housing to accommodate the RX100 IV
or RX100 V camera, the C‐shaped washer should be removed.
Important Notice: This procedure should only be followed if using the housing to accommodate the
RX100 III camera. Installing the C‐shaped washer when using the housing with the RX100 IV /
RX100 V camera will interfere with housing functionality and potentially damage the camera
and/or housing!
INSTALLING THE CAMERA
Since the
FRX100 VA S Housing
is specifically designed for the
Sony RX100 V, RX100 IV
and
RX100 III
digital cameras, installing the camera in the housing is quite simple.
1.
Make sure the camera is turned off.
Image #10
Image #11
Black plastic 2‐
pointed seat at
end of shaft
C‐shaped
washer
Housing
backdoor
