18
FRX100 VA S Housing Instruction Manual 20220601
6.
The white O‐ring featured on the back side of the front door should be visually inspected prior to
each dive. If there is any debris present, gently wipe the area with a soft microfiber cloth in order to
cleanse it.
7.
The white O‐ring featured on the back side of the front door shouldn’t be removed unless it’s
damaged.
WHEN INSTALLING THE RX100 III CAMERA INSIDE THE HOUSING
If using the housing to accommodate the RX100 III camera a small plastic C‐shaped washer (included)
should be installed on the Select / Rotary Wheel control of the housing prior to installing the camera
inside. This C‐shaped washer enables an easier and smoother use of this control with the RX100 III
camera. The C‐shaped washer should only be installed once following this procedure:
1.
Open the back side of the housing.
2.
Identify the Select / Rotary Wheel control on the interior back side of the housing.
3.
Gently remove the black rubber disc installed at the end of this control by pinching it and then
gently pulling it out using your fingers. Pull it away from its black plastic 2‐pointed seat (image
#9).
4.
Remove the plastic C‐shaped washer out of its bag and use small needle nose pliers to securely
hold it without damaging it (image #10 on the
following page).
5.
Using one hand, press the Select / Rotary
Wheel control from the exterior side of the
housing, so the metal shaft sticks out from the
inside.
6.
Using your second hand, install the plastic C‐
shaped washer on the control shaft. First,
using small needle nose pliers, hold the C‐
shaped washer against the shaft so it’s
positioned between the housing backdoor and
the black plastic 2 pointed seat installed at the
end of the shaft. Then push the C‐shaped
washer against the shaft until it snaps securely
into place (image #11 on the following page).
Image #9
