15
Australia
To fi t the small inner burner, fi nd the larger
electrode notch in the burner rim. Line this up with
the white ignition electrode and place the inner
burner on the large base ring.
A electrode notch
B
ignition electrode
Now fi t the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS
THESE WILL DAMAGE THE SURFACE.
Control Panel and Doors
Avoid using any abrasive cleaners including cream
cleaners, e.g. Jif, on brushed Stainless Steel surfaces.
For best results use a liquid detergent.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water -
but take care that no surplus
water seeps into the appliance.
Wipe with a clean
dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.
Stainless Steel Cookers with window doors
If the inside face of the glass on window door
model becomes marked, the oven door front panel
can be taken off so that the glass panels can be
cleaned.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of these
instructions).
Open the oven door slightly and remove the front
panel fi xing screws from the door sides (two each
side).
stainless steel window doors only
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned - take
care not to disturb or wet the door insulation.
Please note that the door is triple glazed but the
inner two panels are fi xed and should not be
separated. After cleaning carefully refi t the outer
door panel and replace the side fi xing screws.
The Ovens
Cleaning is easier if carried out while the oven is still
warm. Before cleaning, cover the burner to prevent
the burner holes becoming blocked.
The inside of the oven and inner door panel can
be cleaned using any cleaner suitable for enamel
surfaces.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven opening.
The enamelled oven burner trim (supplied with
some models only) can be removed for cleaning.
The oven burner trim hooks onto the front of the
oven burner bracket.
When refi tting make sure that the trim is in the
middle of the front of the oven burner bracket.
