36
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Conversion to another gas
Conversion from Natural gas (1.0kPa)
to LPG X Propane (2.75kPa)
This conversion must be performed by a competent
person. After conversion the installation must
comply with the relevant regulations and also the
local electricity supply company requirements.
Read the instructions before converting this
appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
This instruction must be used in conjunction with the
appliance instruction, in particular for information on
Standards, cooker positioning, connection hose suitability
etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Hotplate
Hotplate jets
Standard burner
Wok burner
A jet, B internal jet, C external jet
Remove burner caps and heads. Remove old jets. Fit new
jets (see the table for correct jets). Reassemble in reverse
order.
Tap adjustment
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill door and R H oven door and remove the
6 fi xing screws underneath the control panel. NB some
models have a plate under the facia held in place by the
bottom fi xing screws.
Slide the control panel to the right.. Pull the control panel
forward. Take care not to damage or strain the wiring.
Disconnect leads from back of switches and timer. Lift
control panel clear of cooker.
Remove the tap bypass screw and fi t the correct new one.
See table for correct screws.
Grill
Grill Jet
spring clip
grill
jet
holder
Lift up the spring clip retaining the grill jet holder and slide
the jet holder out of the burner venturi. Remove grill jet
from adaptor and fi t new jet (see table for correct jet). Put
the jet holder back in the burner venturi.
Tap adjustment
Remove the tap bypass screw and fi t the correct new one.
See table for correct screw.
Ovens
Oven Burner Jets
Open oven door and remove oven furniture. Remove
securing screw at the right hand end. The burner is held
in place by dimples in the mounting bracket. Slide the
burner to the left and lift up taking care not to disturb
ignition electrode or the fl ame supervision device electrode
positions.
Remove oven jet from adaptor and fi t new jet (see table for
correct jet).
Reassemble in reverse order.
Oven thermostat Bypass
Remove the thermostat bypass screw and fi t the correct
new one for both ovens. See table for correct screws.
