Falcon Classic 110 gas, Руководство пользователя

Страница: 35 / 39

35
WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Taking care to protect your fi ngers in case the bulb should
shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn on
the electricity supply and check that the bulb now lights.
30. To Change Grill Injector
Disconnect from electricity supply.
Remove the hotplate control panel, see 1.
spring clip
grill injector holder
Lift up the spring clip retaining the grill injector holder and
slide the injector holder out of the burner venturi. Remove
grill jet from adaptor and fi t new jet (see table at the back of
the book for correct jet). Put the injector holder back in the
burner venturi.
31. To Change Grill Burner
Disconnect from electricity supply.
Remove grill injector see 30.
A grill electrode plate fi xing screw
B position of grill burner fi xing screws
C front shield fi xing screws
D grill venturi
Remove the 2 screws holding the front shield and remove
the shield. Turn the grill venturi clockwise to clear the front
cross-member, lift up and remove. For models with ignition
disconnect the electrode lead and remove the screw
holding the plate around the grill electrode. Support the
grill burner from below and remove the two screws (under
the foil wrap) securing grill burner the top of grill chamber.
Remove grill burner.
Reassemble in reverse order taking care not to damage the
grill electrode (where fi tted).
32. To Change Grill Electrode
Disconnect from electricity supply.
Remove the grill burner see 31. Withdraw electrode and pull
off electrode lead. Fit lead to new electrode.
Reassemble in reverse order and check ignition is
satisfactory
33 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fi xing screws and use the
notch and a fl at bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity