31
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Servicing Notes
This appliance must be serviced by a Authorised Person in
accordance with the instructions.
When servicing or replacing gas carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion. When
checking for gas leaks use a liquid leak detector at all joints
and connections to check for leaks in the system. Use a
product specifi cally manufactured for leak detection.
Leak testing of the appliance shall be conducted in
accordance to the manufacturer’s instructions.
CAUTION: DO NOT USE A FLAME TO CHECK FOR
GAS LEAKS.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from electricity supply before commencing
servicing, particularly before removing any of the following:
control panel, side panels, cooktop tray, or any of the
electrical components or cover boxes. Before electrical
reconnection check that the appliance is electrically safe.
1 To Remove the Control Panel
Disconnect from electricity supply.
Classic model only
Remove the handrail by removing the 2 end bracket
fi xing screws.
Pull off the push fi t control panel end caps at each end
and remove the end fi xing screws under the end cap.
Open the oven door & or grill door and remove the fi xing
screws underneath the control panel. NB some models have
a plate under the control panel held in place by the bottom
fi xing screws.
Pull off all the control knobs.
Other models
Slide the control panel to the right.
Pull the control panel forward. Take care not to damage or
strain the wiring.
Disconnect the wiring from the rear. Reassemble in reverse
order. When replacing leads refer to the wiring diagram.
Check operation of timer.
2. To Remove Hotplate Trays
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear
Left hand tray
From the rear remove the screws securing the fl ue
grille to the hotplate tray. Remove pan supports,
burner heads and caps. Remove the 4 screws and
washers holding the hotplate tray to the frame.
Raise the front of the hotplate then withdraw.
Right hand tray
From the rear remove the screws securing the fl ue
grille to the hotplate tray. If the LH hotplate has
not been removed, slacken the screws holding
the L H tray. Remove pan support, burner head,
caps and trim rings. Remove the screws holding
the Wok burner to the hotplate. Remove the
two screws and washers holding the RH tray to
the frame. Press the Wok burner down slightly
and, taking care not to damage the Wok burner
electrode, slide the tray about 30mm to right to
clear the locating brackets on the R H side. Lift tray
slightly at the front and taking care not to stress
the Warmer/lead junction, disconnect the leads
to the Warmer neon and separate the leads at the
piggybacks. Withdraw the hotplate.
Reassemble in reverse order ensuring that the leads are
reconnected. When replacing the RH hotplate take care not
to damage the ignition electrode of the Wok burner.
It is important that the rear fi xing screws are refi tted as they
from part of the cooker earthing.
On some models there is a separate plate.
A fl ue grill, B cooker backsheet, C earthing/fi xing screws
On others it is a tag on the cooker backsheet.
It is important that the tag is on the outside and that both
fi xing screws are fi tted.
A fl ue grill, B cooker backsheet, C earthing/fi xing screws
Check for correct burner operation.
