Fagor 8040 MC CNC, Руководство пользователя

Страница: 79 / 247

Chapter 2 - page 17
MC work mode
2.5.2.1 DEFINE THE TOOL IN THE TOOL TABLE
To define a tool in the tool table take the following steps:
Select the tool number to be defined
Press key to select field «T»
Key in the tool number to be defined and press key
If the tool is defined, the CNC will display the values stored in the table.
If the tool is not defined, the CNC will assign it a offset with the same number and all the data
that define the geometry and lengths of the tool will be reset to value 0.
Select the offset number to be associated with this tool
The "D" field must be selected. If not, use the keys.
Key in the offset number to be associated with the tool and press
Define the tool dimensions
The tool data is: R Radius I Radius wear
L Length K Length wear
Even if the tool length is known (L), it is recommended to measure
it as indicated in the next section. Once it has been measured, the
CNC updates the L and K fields.
The CNC assumes (R+I) as the real tool radius and (L+K) as the real tool length.
To set these values, select the corresponding field using the , key in the desired
value and press
Define the rest of the data associated with the tool
Nominal life. Machining time (in minutes) or number of operations
that the tool may carry out.
Actual life. Machining time already elapsed or number of operations
already carried out.
Family code. Used with automatic tool changer.
0 ... 199. normal tools, 200 ... 255 special tools.
When requesting a worn-out (expired) tool ("actual life" greater than "nominal life"), the CNC will
select the next tool in the table belonging to the same family instead of the one requested.
Tool status. They are 2 fields for internal CNC data. They cannot be modified.
N = Normal (family 0-199) A = Available
S = Special (family 200-255) E = Expired (“actual life” greater than “nominal life”)
R = Rejected by the PLC
To define these values, select the corresponding field using the key in the
desired value and press
2. Operating in JOG mode
2.5 Tool control
2.5.2 Tool calibration