Fagor 8040 MC CNC, Руководство пользователя, Страница: 68 / 247

Chapter 2 - page 6
MC work mode 2. Operating in JOG mode
2.2 Axis control
2.2 AXIS CONTROL
2.2.1 WORK UNITS
Whenever the MC work mode is accessed, the CNC assumes the work units, «mm or inches»,
«millimeters/minute or millimeters/revolution», etc., that are selected by machine parameter.
To modify these values the M work mode has to be accessed, modifying the relevant machine
parameter.
2.2.2 COORDINATE PRESET
Coordinate preset must be made axis to axis, in the following stages:
1st Press the key for the axis required , or
The CNC will frame the position for said axis, to indicate that this is selected.
2nd Enter the value required for preset of the axis.
To exit coordinate preset press
3rd Press so that the CNC assumes said value as the new value for the point.
The CNC requests confirmation of the command. Press to confirm or
to exit preset.
2.2.3 HANDLING THE FEEDRATE OF THE AXES (F)
To set any particular value for the axis feedrate, proceed as follows:
1st Press
The CNC will frame the present value, to indicate that this is selected.
2nd Enter the new feedrate required.
To exit coordinate preset press
3rd Press for the CNC to assume said value as the new feedrate for the axes.