Usermanual 4TrackTrigger TP2.5 11 / 18
Track Deck mode
All buttons in the Key-Arrays
as
well as the encoder and the buttons in the deck sections have
different functions and subsequently also different commands in the Remix- and Track Deck modes.
The only exception being the Deck Size function (Shift + M.loop-button), which send the same
commands for all modes. The Live Input mode has the same commands as the Track Deck mode.
Traktor reports the Deck modes back to the device so that it is even possible to carry out switching in
the Traktor Preferences, respectively the controller following the configuration of Traktor.
LED bars in the Key-Array
– the LED indication displays the present position in the loaded track by a
spot. A completely lit up display (apart from the spot indication) shows the play operation. A Track-
End-Warning is indicated by the whole display blinking.
Hotcue LEDs
– The LEDs in the Track Deck mode show an existing Hotcue.
Deck Displays –
The Track Deck mode always shows the loop size, unless the Move / Size Encoder
is pressed, the indication switches between Move-Size (Encoder 4) and Loop-Size (Encoder 3). The
red LEDs next to the encoders show, which parameter is presently on the display. The loop lengths
and move lengths are indicated directly. The decimal points serve as dividers for the indications.
Key-array
Control element
Function
HOTCUE 1-8 Button
Each deck has eight Hotcue buttons numbered from 1 to 8. In Traktor, you can
assign any stored Cue Point or Loop to one of the 8 Hotcue buttons. This allows for
instant access to your most important Cue Points and Loops. Using stored Cue
Points, you can mark specific positions in your tracks; e.g. beginning vocals,
instrumentals or breaks. Storing a Cue Point instantly maps it to the next available
Hotcue.
SHIFT + HOTCUE 1-8
Button
Shift + Hotcue 1-8 deletes stored Cue Points 1-8
PLAY Button (red)
Push the Play button to start or stop playback. The Led bar indicates activation or
deactivation of Play, at track end warning the Play Led bar is blinking.
SHIFT + PLAY Button
(red)
The Cue button has multiple functions depending on the playback state of the track.
On a paused deck, pushing Cue sets a new current cue Point at the current play
position. In Snap mode this cue point will snap to the beat nearest the play position.
Pushing Cue during playback jumps the current play position back to the previously
set current cue point and stops playback
LOOP ACTIVE Button
(next to the Loop Led)
To activate / deactivate a loop push the Active button. The Led in the deck section
indicates activation or deactivation of a loop.
SHIFT + LOOP ACTIVE
Button (next to the Loop
Led)
To set a loop with a pre-selected length (Loop set), push Shift + Loop Active Button.
The Loop Led indicates when a track is currently in loop mode.
BEATJUMP
FWD Button
(
next to the Shift Button
)
Serves to move a Beatjump one beat forward. (Attention! The Move mode is always
set to Beatjump as well as the Move size adjusted to 1 beat.)
Содержание 4TrackTrigger
Страница 1: ...Usermanual 4TrackTrigger...
