Faber TIMRA, Инструкция по установке и Руководство пользователя

Страница: 18 / 23

UK/IRL
UK/IRL 35
9. SAFETY INSTRUCTIONS FOR THE
USER
9.1 General safety instructions
If a gas leak is found or suspected, turn off the gas supply at the meter and
contact your installer or gas emergency service.
These instructions should be read carefully and retained for future reference.
Do not use the fire with a broken or damaged glass.
The fire has a safety device which turns off the gas supply if there is a build up from
flue gasses in the combustion room or a temporary gas cut-off. Wait at least
5 minutes before turning the appliance on again. Contact a qualified installer when
the appliance goes off regularly
The appliance has been designed for heating purposes. This means that all surfaces,
including the glass, can become very warm (over 100 °C). An exception to this is the
lower side of the ash tray door and the control buttons.
Due to the newness of materials, they may give off a slight smell for a period after
initial lighting. This is normal, odours will disperse after a few hours use.
Do not place curtains, clothing, laundry, furniture or other flammable materials nearby
the appliance. The required minimum distance is 100 cm.
Switch off the receiver of the remote control if you don’t use the fire for a long time. Do
not let children use the remote control without supervision.
UK/IRL
UK/IRL 36
Important
A suitable Fireguard conforming to BS6539 and BS6778 should be used with this
appliance to protect children, the elderly or infirm. Care should also be taken with pets.
In your own interest and that of safety, all gas appliances must be installed by
competent persons. Installation must be in accordance with National Regulations.
CORGI registered installers are required to work to recognised standards.
Note:
Since the appliance is a source of heat, circulation of air occurs. Therefore it is of
importance that you do not use the appliance shortly after a renovation of the home.
Because of the natural circulation of air, moist and volatile components from paint,
building materials, carpet etc. will be attracted. These components can settle
themselves down onto cold surfaces in the form of soot. As on all heat producing
appliances, soft furnishings such as blown vinyl wallpaper placed too near to the
appliance may become scorched or discoloured. This should be born in mind when
installing the appliance.
We advise you to leave the pilot flame on. Leaving the pilot flame on reduces the
amount of condensation when starting the appliance and increase the life time of the
appliance.