Faber TIMRA, Инструкция по установке и Руководство пользователя

Страница: 21 / 23

UK/IRL
UK/IRL 41
10.4.1 To light
1. Push in and turn the control knob (A) from anticlockwise to the
setting (small flame). You will hear an ignition click. Check that the
pilot is lit (if not repeat).
2. Continue to hold in the control knob for a further ten seconds to
ensure that the pilot flame is stable.
3. Release the knob. The pilot should remain alight.
4. Turn the control knob A to the position.
5. Set the on/off switch on the receiver to "on”.
low flame
high flame
6. Use (high) and (low) to achieve the desired heating and flame effect.
7. You will hear a beep every time the receiver recognises a good signal. (If not, so
see 10.4.3, setting the right transmission code).
8. When the fire is not be used for a prolonged period, turn off the remote control
using the on/off switch on the receiver.
l
UK/IRL
UK/IRL 42
10.4.2 To extinguish
1. Push (low) till the burner goes out and you can hear the motor clicking.
2. To enable the remote control turn knob A to the position.
3. To extinguish the pilot turn control knob A to position although it is in order to
leave the pilot permanently lit.
10.4.3 Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already done at the
factory. However the code can disappear if the receiver is disconnected from the
mains for a longer period.
1. Push the "mod" button on the receiver and hold it for 3 seconds.
2. The green control lamp will light up and stay on. Repeat this step if not.
3. Push a button on the remote control. The control lamp on the receiver should now
go out.
4. Again push a button on the remote control. The lamp starts flashing and will switch
off eventually.
5. The receiver now recognizes the remote control. The remote control now functions.
6. Check if you can hear a sound and the motor runs, when you push a button on the
remote control. (If not so please check the batteries).
10.4.4 Changing the batteries
There is no risk of electric shock as the low voltage supply is similar to that used in
torches. Always turn off the appliance before changing batteries.