FAAC 617, Руководство пользователя

Страница: 8 / 32

6
ENGLISH
10
0
50
410
10
85
21
0
21
0
Ø80
20 - 22 mm 410
M12
450
25
0
200
A B
3
1
2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
1
2
Fig.8
3.DIMENSIONS
Dimensions in mm
4. INSTALLING THE AUTOMATED SYSTEM
4.1 PRELIMINARY CHECKS
To ensure safety and an efficiently operating automatic system,
make sure the following conditions are observed:
• when moving, the beam must not, on any account, meet
any obstacles or aerial power cables.
• the soil must permit sufficient stability for the foundation plinth.
• there must be no pipes or electrical cables in the plinth
excavation area.
• if the barrier body is exposed to passing vehicles, install, where
possible, adequate means of protection against accidental
impact.
• check if an efficient earth plate is available for connection to
the upright.
4.2. MASONRY FOR FOUNDATION PLATE
• assemble the foundation plate as shown in figure 4.
• make a foundation plinth as shown in fig.5 (referred to clayey
soil).
• wall the foundation plinth as shown in fig.5, providing one or
more sheaths for routing electrical cables.
• using a spirit level, check if the plate is perfectly horizontal.
• wait for the cement to set.
• unscrew the 4 upper nuts, which will be used later on to
secure the upright.
4.3. MECHANICAL INSTALLATION
• using the four supplied nuts, secure the upright on the
foundation plate as shown in fig.6.
• remember that the upright door should normally face the
building.
• prepare the operator for manual operating mode as
described in chapter 6.
Attention: The automated system is supplied ready for left-hand
installation (fig.7 ref. A).
Procedure for modifying the automated system from left- to right-
hand
(fig.7 ref.B) .
• remove the tie-rod ref.1 fig.7.
• move the control unit from right to left ref.2 fig.7.
• position the tie-rod ref.1 fig.7 on the hole to the right of the
control unit.
• move the spring securing plate ref.3 fig.7 from the left pin to
the right pin.
• remove the screws which fasten the rod carrier plate, fig. 8.
• rotate the rod carrier plate, ref.2 fig. 8, by 90°.
• re-fasten the whole assembly with the screws.