extronics iWAP XN3, Инструкция по установке и эксплуатации

Страница: 7 / 28

XN3 Installation and Operating Manual
7
Avertissements! La liaison à la terre de la plaque de protection de l’iW AP
XN3 ne doit pas être retirée.
Warning! The XN3 internal power input connector has an earth
connection, which must be terminated to the protective earth
conductor of the incoming power supply.
Warning! The XN3 must NOT be installed in hazardous areas requiring
Category 1, 2, M1 or M2 equipment.
Warning! The XN3 enclosure must NOT be opened when an explosive
gas or dust atmosphere is present, or when the equipment is
energized.
Avertissements! L’iWAP XN3 ne doit pas être ouvert dans u ne atmosphère
contenant de la poussière ou un gaz explosif, ni lorsque
l’équipement est sous tension.
Warning! The XN3 enclosure must be secured only with the bolts
supplied, and these must be tightened to the correct torque
value. See Section 3.2.2 for details. Contact Extronics for
replacement bolts.
Avertissements! La plaque de protection de l’iWAP XN3 ne doit être fixée
qu’avec les boulons fou rnis et serrés à la valeur de
couple correcte.
Warning! The XN3 enclosure must only be fitted with suitably approved
cable entry devices. See Section 3.3 for details.
Avertissements! L’iWAP XN3 ne doit être monté qu’avec des composants
d’entrée de câbles correctement évalués.
Warning! Do not exceed the RF Threshold Power for the equipment
group in which the XN3 and its antennas are to be
installed; it must be controlled in accordance with IEC 60079-
0, and must not exceed the following levels:
IIC
– 2W (+33dBm)
IIB – 3.5W (+35.4dBm)
IIA – 6W (+37.7dBm)
III – 6W (+37.7dBm)
See Section 3.10.1 for an example of how to calculate the RF
Threshold Power