extronics iWAP XN3, Инструкция по установке и эксплуатации

Страница: 12 / 28

XN3 Installation and Operating Manual
12
3.2 Opening and Closing the Enclosure
3.2.1 Opening the front cover plate
• Remove all bolts using a metric hex key. Store the bolts carefully to avoid
damage or loss.
• Ensure care is taken when removing the cover. Do not use a screwdriver or any
other sharp implement to prise the cover apart as it may damage the sealing
gasket.
3.2.2 Closing the Enclosure
• Inspect the gasket to ensure its sealing integrity. If the front cover gasket is
damaged it must be replaced.
• Check all bolts are the correct type and free from damage.
• Re-insert the bolts and hand-tighten only.
• Using a torque wrench fitted with an 3mm hex head, tighten the bolts in
opposite corners of the enclosure, then work clockwise around the front cover.
Tighten to a torque of 3.5Nm.
Figure 1: Opening XN3 Front Cover Plate