Extron electronics SMP 111, Руководство пользователя

Страница: 58 / 124

SMP 111 • Web-Based User Interface 50
System Settings
Controls within seven of the ten panels in the
System Settings
page within
Configuration
are essential during initial setup of the unit. The three other panels
contain features that are used infrequently for updating the unit, restoring a configuration, or
limiting access to front panel controls. A user must be logged in as an administrator to see
or change these settings.
To open this page, click the
Configuration tab (see figure 42) at the top of the SMP 111
embedded web pages and then click the System Settings tab on the second tier of
tabs.
Figure 42. Configuration Tab, System Settings Subtab
The System Settings page opens (see figure 43).
1
2
3
4
5
6
7
8
9
10
Figure 43. System Settings Page
The panels are:
1
Unit Identification — Set the system (unit) name and a descriptive name for its
location. This is also the read only location of the model name, description, part number,
serial number, firmware version, overall unit temperature, remote panel connection,
remote panel firmware, and enabled feature licences.
2
Date and Time — Set the date, time, time zone, and settings for syncing with one or
more NTP (network time protocol) servers.
3
Networking — Set the IP address, subnet mask, gateway, and DNS server, as well as
the port information for a variety of port types, or enable or disable SNMP.
4
Recording Media Selection — Recording parameters, such as recording size and
destination, can be set and saved from this panel (see Setting the Default Recording
Media on the next page).
5
Default Recording File Names — Allows the user to choose what type of
information will be used to compose names of recordings and what type of file
extension (m4v and mp4).
6
Marks and Thumbnails — Choose whether to have the SMP produce normal (small)
size thumbnail images of the recorded video or to make thumbnail images the same
size (resolution) as the recording encoder settings and the frequency.
7
Serial — Set the baud rate and protocol for the rear panel remote control serial port.
figure 42
figure 43