Extron electronics SMP 111, Руководство пользователя

Страница: 19 / 124

SMP 111 • Installation 11
Control System and External Device Connections
The SMP 111 can be configured and controlled from the rear panel RS-232 captive screw
port (see
figure 3 ,
F
on the previous page), the front panel mini USB B Config port
(see figure 6 ,
C
on page 15), or the LAN port (see figure 3 ,
J
) using SIS commands
and DataViewer via Telnet port 23. It can also be configured and controlled using a standard
web browser from the LAN port. Because the LAN port must be connected for streaming
output, Extron recommends using it for configuration, control, and firmware upgrades.
B
USB storage device — You can attach an optional external USB storage device to the
front or rear USB ports to save recorded files. The storage device can be any standard
external hard drive or USB flash drive formatted with a compatible file system.
NOTE: The SMP 111 can detect and record to USB storage devices using FAT32,
VFAT long file name extensions, EXT2, EXT3, EXT4 file systems, or NTFS-
formatted storage volumes.
F
Remote RS-232 port — You can configure and control the SMP 111 using
SIS commands. Connect the host RS-232 cable to the rear panel with a 3-pole
captive screw connector for bidirectional serial host control (see the image at
right for wiring).
G
Remote Control connector — You can control the SMP 111 using an optional
RCP 101, Flex55, AAP, or decorator-style wallplate.
H
12V external power output — The SMP can provide external power to
the optional RCP 101 EU/MK, AAP, or wallplate through this 2-pole captive
screw connector. The 12 V power is required to power up an RCP 101 remote
controller.
J
RJ-45 Ethernet connector (LAN) — You can configure and control the SMP 111
using SIS commands with a control system or PC connected to the same LAN or WAN.
Connect a standard Ethernet cable to a network.
IP Address: 192.168.254.254
Subnet Mask: 255.255.0.0
Default Gateway: 0.0.0.0
DHCP:
OFF
Tx Rx
RS-232
G
REMOTE
Ground
Receiv
e
Tr
ansmit