NAV E 401 D and NAV E 201 D Encoders • Installation
7
Prepare the Site
To prepare the site:
1.
Using either of the following sizing methods:
•
Print the applicable mounting template, available on the Extron
and tape
your template to the mounting surface.
•
Place the wall box against the installation surface, and mark the opening guidelines.
2.
Cut out the material from the marked area. Protect the surface prior to and while cutting
so the surface is not damaged.
3.
Test the fit by inserting the encoder or wall box (if applicable) into the opening. The rear
connectors on the encoder should fit easily into the opening.
4.
Enlarge or smooth the edges of the opening if needed.
5.
If using a mounting bracket
, install the junction box or mud ring into the wall or
furniture (see figure 2).
Detail A
0.75" #6-32 Screw
Backing Clip
Backing Clip
Sheet Rock
Sheet Rock
Mounting Bracket
Mounting Bracket
Detail B
1.25" #6-32 Screw
Backing Clip can
be in either orientation.
See
Detail A
or
Detail B.
Figure 2.
Installing a Mounting Bracket
a.
Place 0.75 (1.90 cm) to 1.25 inch (3.18 cm) long #6-32 machine screws through
the large holes in the four corners of the mouting bracket.
b.
Loosely fasten the mounting bracket clip to the on the end of each screw.
c.
Insert the mounting bracket into the opening in the wall (see step 2).
d.
Rotate each mounting bracket clip so that the tab is behind the installation surface
to hold the bracket suggly against the surface when the screw is tightened.
NOTE:
The mounting bracket clip can be installed as shown in Detail A or
Detail B of figure 2.
e.
Use a screwdriver to fasten the screws and bracket slips in place.
6.
If using a junction box
, secure it with nails or screws, leaving the front edge flush with
the outer wall or furniture surface (see
on page 8).
NOTE:
Read any installation instructions and UL guidelines that come with the
mounting devices, then install the box or mud ring in the opening at the installation
site.
Содержание NAV E 201 D
Страница 6: ......
Страница 8: ...NAV E 401 D and NAV E 201 D Encoders Contents viii...
