Extron electronics MediaLink IPI 100 Series, Руководство пользователя

Страница: 59 / 64

Mounting
This section describes:
•
Mounting the IPI 100 Series
•
Mounting the IPI 200 Series
Mounting the IPI 100 Series
The IPI intercom and any other adapter plates must be attached to a device faceplate or AAP
wall plate and cabled before the device or wall plate is installed in a wall or furniture. The screws
needed for installing the IPI are built into its front panel.
1.
Before cables are attached, insert the IPI screws through the holes in the device faceplate
or AAP mounting frame. Secure the intercom module to the faceplate/wall plate with the
provided captive washers and #4-40 nuts, as shown below:
Ext
ron
PR
OJEC
TO
R
MLC 226 IP A
AP
1
2
3
4
5
6
VO
LUME
CONFIG
IR
PC
AU
X
VIDE
O
DV
D
VC
R
DO
C
CAM
LAPT
OP
AU
TO
IMA
GE
MUTE
ON
OF
F
Extron
MLC 226 IP AAP
MediaLink Controller
Extron
IPI 104 AAP
Intercom
#4-40 Nut w/ Captive
Washer
(included)
INTERCO
M
MIC ON
1
2
3
4
IPI 104
PUSH
TO
CALL
SECURITY
LA
B
ADMIN
OFFICE
HELP
DESK
Figure 34. Mounting the IPI 100 Series
2.
Connect each IPI to an MLC via the RJ-45 intercom ports on both devices using the
included cable. If a longer cable is required, use a standard CAT 5, CAT 5e, or CAT 6 straight
through network cable. See
IPI Rear Panel Features and Cabling on page 6.
3. Mount the AAP mounting frame or other device to the wall, furniture, or rack panel. Follow
any special mounting instructions that came with that device.
IPI 100 and IPI 200 Series • Mounting 51