IPI 201 and IPI 204 Models Only
C
LAN port
(IPI 201 AAP and 204 AAP only) (see
figure 2
on page 6) — Plug an RJ-45
jack into the LAN connector to connect to a network. The blinking yellow LED indicates LAN
activity. The green LED lights to indicate a good LAN connection. For wiring, see
figure 4
on
the previous page.
D
Power
(see
figure 2
) — Connect a cable between the 2-pole, 3.5,mm captive screw
connector and a 12 VDC, 1 A power supply (included).
ATTENTION:
•
If not provided with a power supply, this product is intended to be supplied by
a UL Listed power source marked “Class 2” or “LPS” and rated output 12V dc,
minimum 1.0 A minimum.
•
Si le produit n’est pas fourni avec une source d’alimentation, il doit être alimenté
par une source d’alimentation certifié UL de classe 2 ou LPS, avec une tension
nominale 12 Vcc, 1 A minimum.
•
The power supply shall not be permanently fixed to the building structure or
similar structures.
•
La source d’alimentation ne devra pas être fixée de façon permanente à une
structure de bâtiment ou à une structure similaire.
•
Do not place the power supply within environmental air handling spaces or the
wall cavity.
•
Ne pas placer les sources d’alimentation dans une zone de traitement de l’air ni
dans une cavité murale.
•
The installation shall be in accordance with the applicable provisions of the
National Electrical Code ANSI/NFPA 70, Article 725 and the Canadian Electrical
Code, Part 1, Section 16.
•
Cette installation doit toujours être conforme aux dispositions applicables
du Code américain de l’électricité (National Electrical Code) ANSI/NFPA 70,
article 725, et du Code canadien de l’électricité, partie 1, section 16.
•
The power supply is to be located within the same vicinity as the Extron
equipment in an ordinary location, Pollution Degree 2, secured to the equipment
rack within the dedicated closet, podium or desk.
•
La source d’alimentation doit être située à proximité de l’équipement de
traitement audiovisuel dans un endroit ordinaire, avec un degré 2 de pollution,
fixé à un équipement de rack à l’intérieur d’un placard, d’une estrade, ou d’un
bureau.
E
Contact Relay
(see
figure 2
) — The 2-pole, 3.5,mm captive screw contact relay connector
is used to control items such as room lighting, window coverings, and door locks. The
contact may be used to control any equipment as long as the contact specifications of 24
VDC at 1 A are not exceeded.
F
Audio Out
(see
figure 2
) — A 3-pole, 3.5 mm captive screw connector is used for audio
output connection. It provides a -10 dBV balanced or unbalanced signal that can be
connected to local, powered speakers or to any audio or paging system.
IPI 100 and IPI 200 Series • Installation
8
Содержание MediaLink IPI 100 Series
Страница 6: ......
Страница 8: ...IPI 100 and IPI 200 Series Contents viii...
Страница 42: ...Figure 33 Server Mode IPI 100 and IPI 200 Series Help Desk Software 34...
