Extron electronics MediaLink IPI 100 Series, Руководство пользователя

Страница: 15 / 64

All Models
A Intercom port (IPI 101 AAP and IPI 104 AAP only) (see figure 2 on page 6) — This port
is used for power, control, and voice data communication with the MLC.
•
Plug one end of a standard, straight through, CAT 5, CAT 5e, or CAT 6 cable terminated
with RJ-45 connectors into this port (see figure 4, below).
•
Plug the other end of the cable into the Intercom connector on the MLC 226 IP rear
panel, as shown in figure 3.
HOST
CONTROL
R
1=DIGITAL I/O
2=Tx 3=Rx 5=GND
38400, N, 8, 1
PRESS TAB WITH
TWEEKER TO REMOVE
INTERCOM
AU
DIO
OUT
LAN
IPI 101 AAP or IPI 104 AAP
Rear Panel
MLC 226 IP Rear Panel
<100’ (30.4 m)
Figure 3.
Connecting the Intercom Port to the MLC 226 IP
ATTENTION:
•
This is not an Ethernet LAN connection. Do not connect these ports to the
Ethernet.
•
Il ne s’agit pas d’une connexion LAN Ethernet. Veillez à ne pas connecter ces
ports au réseau Ethernet.
NOTE:
A 12 inch (30.5 cm) CAT 6 cable is included with each IPI. If you choose to
terminate your own cable, the cable must be no longer than 100 feet (30.4 m). Cables
must be terminated to the T586A or T586B standard and both ends of a cable must
be wired to the same standard (see cable wiring in figure 4).
Patch (straight-through) cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Clip Down
Side
1
1&2
3&6 4&5
7&8
234567 8
Pins
12345678
RJ-45
connector
Twisted
Pairs
Figure 4. RJ-45 Wiring
B AAP mounting screws (see figure 2 ) — These four screws are permanently attached to
the IPI faceplate. They are used for mounting the faceplate into another device (such as an
MLC 226 IP AAP) or a mounting frame.
IPI 100 and IPI 200 Series • Installation 7