Extreme Networks Summit WM3000 Series, Справочное руководство

Страница: 179 / 513

Summit WM3000 Series Controller System Reference Guide
179
4 Refer to the Properties field (in the lower portion of the Configuration tab) for the following
5 Click on the Show Filtering Options link to set filtering parameters to filter information displayed on
the screen. Once the Show Filtering Options link is selected, the
Filter Option Zone which allows the
selection of filtering parameters is displayed. Up to two parameters may be selected.
Within the Filter Option Zone the following options are presented:
●
And / Or - Use the And/Or drop down list to expand the selection criteria. Upto two selection
criteria are supported.
●
Filter Entire Table - Click Filter Entire Table to apply the filtering criteria on the information being
displayed on the screen.
●
Turn Off Filtering - Click Turn Off Filtering to turn off filtering and display all information. Use this
button and the Filter Entire Table button to refresh screen contents after making changes to the
filtering criteria.
When filtering is disabled, a message is displayed at the bottom of the screen. Similarly, when
filtering is enabled, the filtering criteria is displayed at the same place on the screen.
MAC Address
The Base Radio MAC is the radio's first MAC address when it is adopted
by the Controller.
State
Display the radio’s current operational mode. If the radio is set as a
Detector AP, the state is "Detector", otherwise the state is "Normal".
VLAN
Displays the name of the VLAN currently used with each Access Point
radio.
Desired Channel
When the radio’s channel is configured statically, the Actual Channel and
Desired Channel are the same. If using ACS (
Automatic Channel
Selection
), the controller selects a channel for the radio. The Desired
Channel displays “ACS” and the Actual channel displays the channel
selected for the radio. When set to Random, the applet determines the
channel’s designation.
AP Manufacturer
Displays the kind of AP listed by each index.
Actual Channel
When the radio’s channel is configured statically, the Actual Channel and
Desired Channel are the same. If using ACS (Automatic Channel
Selection), the controller selects a channel for the radio. The Desired
channel displays “ACS” and the Actual Channel displays the channel
selected for the radio.
Desired Power (dBm)
Displays the configured power setting in dBm for the selected radio. In
most cases, the Desired Power and Actual Power are the same unless the
desired power level would put the radio's output power outside the
accepted regulatory compliance range.
BSSIDs
Displays the BSSIDs used by the displayed radio index.
Actual Power
Displays the current power level in dBm for the selected radio. In most
cases, the Desired Power and Actual Power are the same unless the
desired power level would put the radio's output power outside the
accepted regulatory compliance range.
Placement
When the radio is adopted using the default configuration, the power for
the radio can be defined as “Indoor” or “Outdoor.” However, some
countries have restrictions for the use of outdoor radios. If using a value
of “Outdoor” verify it is in compliance with the country of operation’s
regulatory restrictions.
AP IP Address
Displays the AP’s IP address.
Last Adopted
Displays the time this radio was last adopted by the controller.
Voice Calls
Displays the current number of active voice calls for the selected radio.