Extreme Networks Summit WM3000 Series, Справочное руководство

Страница: 111 / 513

Summit WM3000 Series Controller System Reference Guide
111
3 Click on the Show Filtering Options link to set filtering parameters to filter information displayed on
the screen. Once the Show Filtering Options link is selected, the
Filter Option Zone which allows the
selection of filtering parameters is displayed. Up to two parameters may be selected.
Within the Filter Option Zone the following options are presented:
●
And / Or - Use the And/Or drop down list to expand the selection criteria. Up to two selection
criteria are supported.
●
Filter Entire Table - Click Filter Entire Table to apply the filtering criteria on the information being
displayed on the screen.
●
Turn Off Filtering - Click Turn Off Filtering to turn off filtering and display all information. Use this
button and the Filter Entire Table button to refresh screen contents after making changes to the
filtering criteria.
When filtering is disabled, a message is displayed at the bottom of the screen. Similarly, when
filtering is enabled, the filtering criteria is displayed at the same place on the screen.
4 Click the Edit button to display a screen where WLAN information, encryption and authentication
settings can be viewed or changed.
5 Click the Enable button to enable the selected WLAN. When enabled, a green check mark displays.
When disabled, a red "X" displays. Enabled WLANs are display in a number of different controller
Web UI configurations for additional configuration activities. To enable or disable a WLAN, select it
from the table and click the Enable or Disable button. The Enable button is only available when the
selected WLAN is disabled.
6 Click the Disable button to disable the selected WLAN. When enabled, a green check mark displays.
When disabled, a red "X" displays. To enable or disable a WLAN, select it from the table and click
the Enable or Disable button. The Disable button is only available when the selected WLAN is
enabled.
7 When using clustering and the Cluster GUI feature is enabled a drop-down menu will be available to
select which cluster members’ WLANs are displayed. To view WLANs from all cluster members,
select
All from the drop-down menu. To view WLANs from a specific cluster member, select that
member’s IP address from the drop-down menu.
Encryption
Displays the type of wireless encryption used on the specified WLAN.
When no encryption is used, the field displays
none
. Click the
Edit
button
to modify the WLAN’s current encryption scheme. For information on
configuring an authentication scheme for a WLAN, see “Configuring
Different Encryption Types” on page 140 .
Independent Mode
Determines whether the WLAN is functioning as an independent or
extended WLAN in regards its support of AP operation.
Independent WLANs (defined by a green checkmark) are local to an AP
and configured from the controller. Specify a WLAN as independent for
no traffic to be forward to the controller. Even though Independent
WLANs behave like WLANs as used on a standalone Access Point for data
traffic, they are totally managed by the controller.
Extended WLAN (defined by the default red X) are typical centralized
WLANs created on the controller.
Select an existing WLAN to revise its default extended mode designation
if intending to use the WLAN for AP support. For more information, see
“Editing the WLAN Configuration” on page 113 .
QOS Weight
Defines the Quality of Service weight for the WLAN. WLAN QoS will be
applied based on the QoS weight value with higher values representing
higher priority. The range for QoS. weight values is between 1 and 10
with 1 being the default value.