S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
4-17
S
UMMIT
C
OMMANDS
Q
O
S C
OMMANDS
Table 4-12
describes QoS commands.
config stpd <stpd_name> port priority <value>
<portlist>
Specifies the priority of the port in this STPD.
By changing the priority of the port, you can
make it more or less likely to become the
Root Port.
The range is 0 through 255. The default setting
is 128. A setting of 0 indicates the lowest
priority.
enable stpd [<stpd_name> | all]
Enables the STP protocol for one or all
STPDs. The default setting is disabled.
disable stpd [<stpd_name> | all]
Disables the STP mechanism on a particular
STPD, or for all STPDs.
enable stpd port <portlist>
Enables the STP protocol on one or more
ports. If STPD is enabled for a port, BPDUs
will be generated on that port if STP is enabled
for the associated STPD. The default setting
is enabled.
disable stpd port <portlist>
Disables STP on one or more ports. Disabling
STP on one or more ports puts those ports in
FORWARDING state; all BPDUs received on
those ports will be disregarded.
unconfig stpd {<stpd_name> | all}
Restores default STP values to a particular
STPD or to all STPDs.
Table 4-12: QoS Commands
Command
Description
show qosprofile {<qosname> | all}
Displays QoS profile information, including the
following:
■
QoS profile name
■
Minimum bandwidth
■
Maximum bandwidth
■
Priority
■
The traffic groupings to which this profile is
applied.
Table 4-11: STP Commands (continued)
Command
Description
SUMMIT.BK Page 17 Thursday, September 25, 1997 12:33 PM