3-16
S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
A
CCESSING
T
HE
S
WITCH
C
ONFIGURING
P
ORT
S
PEED
AND
D
UPLEX
S
ETTING
By default, the Summit is conÞgured to use autonegotiation to determine the port speed
and duplex setting for each port. You can select to manually conÞgure the duplex
setting and the speed of the 10/100 Mbps ports on the Summit2, and you can manually
conÞgure the duplex setting on the Summit1.
Ports 1 through 16 on the Summit2 can connect to either 10Base-T or 100Base-T
networks. By default, the ports autonegotiate port speed. You can also conÞgure each
port for a particular speed (either 10 Mbps or 100 Mbps).
Gigabit Ethernet ports on both the Summit1 and the Summit2 are statically set to 1
Gbps, and their speed cannot be modiÞed.
All ports on the Summit1 and Summit2 can be conÞgured for half-duplex or full-duplex
operation. By default, the ports autonegotiate the duplex setting.
To conÞgure port speed and duplex setting, use the following command:
config port <portlist> auto off {speed [10 | 100]} duplex [half |
full]
To conÞgure the Switch to autonegotiate, use the following command:
config port <portlist> auto on
P
ORT
C
OMMANDS
Table 3-6
describes the port commands.
Table 3-6: Port Commands
Command
Description
config port <portlist> auto on
Enables autonegotiation for the particular port
type; 802.3u for 10/100 Mbps ports or 802.3z for
Gigabit Ethernet ports.
SUMMIT.BK Page 16 Thursday, September 25, 1997 12:33 PM
