2 = Flush mount, power supply side to switch I/O port
side airflow
5 = Airflow direction
3 = Cool air intake side
This section details the installation of the optional rack mount kit for a four-post rack and covers
installing:
•
The rack mount rail and extension assembly to the rack.
•
The SSA switch to the rack mount rail and extension assembly.
The optional rack mount kit contains two pre-assembled rack mount rails with attached extensions. The
length of each assembly is adjustable from 56 to 81 cm (22 to 30 in.). Each assembly is labeled either
“right front” or “left front”. The front of the rack is always the cool air intake side. The rear of the rack is
always the hot air exhaust side.
Installing the Rack Mount Rail with Attached Extension Assembly
Refer to
as you perform the following procedure. You must supply eight rack screws to install
the rack mount rails in the equipment rack.
Figure 25: Installing the Rack Mount Rail with Extension Assemblies
1 = Rack mount rail with extension assembly
4 = Rack rear (hot air outlet)
2 = Right/left front assembly label location
5 = Rail assembly adjustment screws
3 = Rack front (cool air inlet)
6 = Airflow direction
To install the rack mount rail with extension assembly, follow these steps:
Optional Rack Mount Rail Kit Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
57
