20
Figure 19
11. The basic assembly is complete, now figure where you want to install the
switches (there are
precut holes just aft of the cowling). Install your tank in the tray just in front
of the wing tube and secure with velcro/zip ties and put foam under tank.
Install any other components you plan to use at this time. Figure 20 shows
where I installed my electronics and accessories.
Figure 20
Receiver switch
Ignition switch
Receiver/ignition batteries
Aircraft receiver
Fuel tank
fuel dot
Second receiver battery
Small hole for access
to high and low
needles on
carburetor.
Typical slot cuts for
stock mufflers.
