17
Figure 15
9. Install the throttle servo, depending on your choice of setup and engine
brand you may have to drill a hole/slot thru the firewall to access the throttle
arm on the carburetor from your servo. With the DA120 motor we mounted
the servo upright in the engine box and cut a small slot in the firewall for the
throttle pushrod. I again chose to file a very small flat spot on the included
throttle pushrod to accommodate the bolt in the easy connector. When
installing the easy connector be sure the round nut is not too tight and to use
blue thread lock. It depends on being able to swivel, the ball link end to the
carburetor installs just like the other connections you have already
performed. Lastly be sure there will no rubbing or binding between the
throttle setup and the cowling or exhaust you choose. Again refer to figures
16& 17.
