10
4. Hinge the rudder and install the control horns using the same technique(s)
as the wing. Then you can mate the rudder to the vertical stabilizer. See
Figures 6 & 7.
Figure 6
5. Mount your rudder servo in the rear (Figure7) or the center mount
location just aft of the wing tube inside the fuselage which will require a pull
pull setup (hardware is included). If you are running stock mufflers a rear
mounted direct drive servo setup works great for CG purposes.
If you want to run cans or pipes you can still use an aft mount servo setup and
then mount your Receiver/ignition batteries further forward if necessary.
Otherwise mounting the batteries in the same location/tray as the rudder
servo will work. See appendix A in the aft portion of this manual for a pull
pull installation.
