Extraflame INSERTO COMFORT MINI, Инструкция по эксплуатации

Страница: 31 / 44

Page 31
11.7 Table of display messages
INDICATIONS
Display
Message
Cause Solution
ATTESA
PULIZIA
An attempt is made to switch on a
stove again when it has just been
shut down (normal shutdown or
caused by an alarm situation).
When the stove has just been shut down (normal
shutdown or caused by an alarm situation), you have to
wait until it is completely cold and then clean the burn
pot.
It is possible to re-start the stove only after having
carried out this operation.
MAS
Room thermostat set at maximum
value.
In this operating mode the stove no longer has a
temperature level but is working manually with all 5
power levels. To exit this function, simply lower the room
temperature by pressing button 2.
MIN
Room thermostat set at minimum
value.
In this operating mode, the stove works only at the 1
st
power level no matter what power is set.
To exit this function, simply raise the room temperature
by pressing button 3.
T ON
An external thermostat has been
connected.
The room thermostat probe is
disconnected.
The room thermostat probe is
interrupted.
To exclude an external thermostat, just disconnect it.
Any other restore operations must be carried out
by an authorised technician.
STBY
The stove is off and on standby to be
re-started.
In this mode, the stove can be switched on/off by means
of a supplementary thermostat (see
“ Mechanical
ther mostat with energy saving”).
To exclude this function, simply raise the room
temperature by pressing button
3
.
DOFF
The stove is off due to the
“Day/Night Temperature Function”
and on standby to be re-started.
To stop the stove from starting again due to the
“Day/Night Temperature Function”, press button 1 and
hold for three seconds, which switches the stove off.
To disenable this function completely, press button 4 and
hold it down, then press button 5.
MANCA CAMPO
Lack of communication between
remote control and stove.
Check the power supply of the stove.
Carry out the procedure “Selecting the operating
frequency” described in the manual.
Remote control energy saving: press button 4 or 5 to
restore correct operation.
N.B.: Certain radio-frequency devices (e.g. mobile and
cordless phones, etc.) may interrupt the communication
between the remote control and the stove.
Any other restore operations must be carried out
by an authorised technician.
RAFFREDDAMENTO
BLAC OUT
No power on the mains
When the shutdown cycle is completed, the stove will
light again automatically.
PULIZIA BRACIERE
The automatic cleaning of the burn
pot is in progress.
The automatic cleaning of the burn pot takes place at
regular intervals of continuous operation.
The automatic cleaning is not carried out when the stove
is in power level 1 position.
PORTA APERTA The fire door is open Keep the door closed during normal operation.