Extraflame INSERTO COMFORT MINI, Инструкция по эксплуатации

Страница: 21 / 44

Page 21
7. REMOTE CONTROL OPERATION
7.1 General description
The radio-frequency remote control has two-way communication with the electronic board,
sending commands and displaying the operating status of the stove.
N.B.: Certain radio-frequency devices (e.g. mobile or cordless phones, etc.) can
interrupt the communication between the remote control and the stove.
Selecting the operating frequency
During the first stove lighting, it is necessary to establish a communication frequency between the
remote control and the stove.
With this procedure it is possible to select one of 4 possible coding methods: this also makes it
possible to use more than one stove inside the same room without one interfering with the
operation of the other. The coding procedure is as follows:
1. Disconnect the power supply from the stove.
2. Remove the batteries form the remote control.
3. Reposition the batteries in the remote control.
4. Press buttons 4 and 5 together for three seconds, until “ SCEGLI UNITA’ ” appears on the
display.
5. Use button 4 or 5 to select the desired coding (from 0 to 3).
6. Power up the stove.
7. The stove will emit two acoustic signals: between the first and the second, press button 1
for 1 second. At this point, the display will show “EXTRAFLAME”.
General characteristics
•
The visual interface is given on an LCD display with
24 characters on 4 lines plus 16 bars.
•
Transmission and reception capacity: 4 metres in
free air space.
•
Display of the operating status of the product
•
Direct controls for switch-on/off, power setting
change
•
Weekly programmer setting
•
Battery power supply (two 1.5 V AA batteries)
•
Dimensions: 61 x 150 x 120 (D x L x W) mm.
7.2 Keypad
Button 1 – ON/OFF unblock
Pressing this button for two seconds enables the
manual switch-on/off of the stove.
If the stove is in alarm status, and therefore blocked,
the button is used for unblocking and subsequent
passage to
OFF status.
During the programming of the user parameters, it is
used to exit and return to the previous menu.
Button 4
Button 5
Button 3 Button 2
Button 1
LCD Display