Extraflame INSERTO COMFORT MINI, Инструкция по эксплуатации

Страница: 34 / 44

Page 34
12.2 Installing a mechanical ther mostat (optional)
N.B.: Installation must be car ried out by an authorized technician.
1. Switch off the appliance using the master switch on the back of the stove.
2. Disconnect the plug from the power outlet.
3. R eferring to the electrical wiring diagram, connect the two thermostat wires to the
respective terminals on the back side of the stove, one red and one black.
12.3 Mechanical thermostat operation
1. Light the stove using button 1 .
2. Set the desired heating power using buttons 4 and 5 .
3. Use the menu 1 button to go to the menu “
SET TEMP AMBIENTE
” and set on “MIN”
using button 4 .
4. Set the desired room temperature on the external thermostat (e.g. 21 °C).
At this point, the external thermostat will control stove operation as follows:
•
Thermostat with closed contact the stove switches on and operates at the power set,
and the display shows “T ON” .
•
Thermostat with open contact the stove goes to the minimum power even if the display
shows the previously set value; the display will then show
“MIN”
.
12.4 Mechanical ther mostat with energy saving, Standby function (Stby)
The Standby function is used to further reduce pellet consumption by switching off the stove when
the desired temperature has been reached.
As the temperature drops, the stove will automatically switch on again.
1. Set the desired temperature using buttons 4 and 5 .
2. Use the menu 1 button to go to the menu “
SET TEMP AMBIENTE
” and set on “MIN”
using button
4
.
3. Press button 1 for three seconds; the display will show “ STBY ”.
At this point the thermostat will control the stove as described below:
•
Thermostat with closed contact: the stove switches on and operates at the power set. The
display shows
“T ON”
.
•
Thermostat with open contact: the stove switches off or stays off, and the display shows
“STBY” .