Extraflame INSERTO COMFORT MINI, Инструкция по эксплуатации

Страница: 29 / 44

Page 29
N.B.: This only occurs when the stove is in “doff” status and not “SPENTO” (OFF)
status.
Manual controls always have priority over the programming.
11.5 Pellet Feed Menu
If the stove has operating problems due to the quantity of pellets, you can adjust the pellet feed
directly from the remote control.
Problems related to the quantity of pellets fall into one of two categories:
1. LACK OF PELLETS :
a. The stove cannot develop a suitable flame, tending to burn very poorly even at high
speeds.
b. At the lowest speed, the stove tends to almost burn out, causing the stove to go
into
“MANCANO PELLET”
alarm status.
c. When “MANCANO PELLET” is displayed, there may still be some unburned pellets
in the burn pot.
2. EXCESS PELLETS:
a. The stove develops a very high flame even at low speeds.
b. The flame tends to soil the stove window, darkening it almost completely.
c. The burn pot tends to get incrusted, blocking the air intake holes, due to the
excessive pellet load that is only partially burned.
N.B.: If this problem occurs just a few months after installation, check to make sure
that the user is correctly carrying out the regular cleaning schedule described in the
instruction manual.
The adjustment is made on a percentage basis, and therefore any change of this parameter leads
to a proportional variation on all loading speeds of the stove.
To access the percentage adjustment of pellet feeding, proceed as follows:
1. Press the menu 1 button the display will show “SET TEMP AMBIENTE”
2. Press the menu 1 button again the display will show “MENU SET OROLOGIO”
3. Press button 5 three times the display will show “MENU REGOLA PELLET”
4. Confirm with the menu 2 button.
When you have entered the programming function, the display will show the following parameters:
Parameter A PELLET FEED
Use buttons 4 and 5 to set the percentage increase/decrease at 5 point intervals (the parameter
can be modified with a maximum scale from -50 to +50). When the adjustment has been made,
press
menu 2 or 1 to confirm and exit.