Extra 300/SC, Руководство по обслуживанию

Страница: 84 / 250

CHAPTER 27
PAGE 25
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 12. February 2019
230 mm (9.06”)
205 mm (8.07”)
30 mm (1.18”)
Figure 17 Pedal Fix Template
4 Secure the rudder in 0°-position.
5 Check that the 550 mm PTFE protective hose is placed on
the pre-assembled control cable.
6 Mount the shackle of the pre-assembled control cable end
to the front cable attachment point. Install bolt LN 9037-
06028 (13, Figure 18), 4 x DIN 125-8.4 washers (7)(two
on both sides of the thimble (10)), 2 x DIN 125-6.3 wash-
ers (6), the bushing EA-33102.4 (11), and the LN 9348-06
nut (8).
7 Thread the cable including the protective PTFE hose through
"S"-shaped tube at the pedal, the fairleads and the hole in the
fabric to the tail. Let the front end of the protective PTFE
hose extend to 20 mm in front of the "S"-shaped tube.
8 Slip 80 mm Ø 1/4" heat shrinking sleeve (2) and 850 mm
protective PTFE hose on the control cable end. The protec-
tive PTFE Hose shall extend 120 mm beyond the first
fairlead inside the fuselage.
9 Pre-install the LN 9037-06030 bolt (5), the DIN 125-8,4
washers (7)(one on both sides of the thimble and one below
the tailwheel steering attachment bracket), the DIN 125-
6,3 washers (6), the bushing (11), the LN 9348-06 nut (8)
and the thimble (10) to the bottom hinge bellcrank.
10 Slip a further 80 mm Ø 3/8" shrinking sleeve and the
NICOPRESS (National Telephone Supply Co., Cleveland
Ohio) 28-3-M sleeve on the cable end.
11 Move the cable around the thimble and tighten to a cable
tension that is just sufficient to release the template at the
rudder pedal.