Extra 300/SC, Руководство по обслуживанию

Страница: 199 / 250

CHAPTER 73
PAGE 6
MAINTENANCE MANUAL EXTRA 300SC
PAGE DATE: 12. February 2019
5 Install cable ties in the cockpit area on positions as marked
before.
6 Install fire sleeve to the throttle control cable and secure
with safety wires at both ends (refer to Figure 2).
7 Install cushioned clamp (4, Figure 4) or cable ties.
8 Install the throttle control cable to the respective brackets
by installing the clamp blocks (3, Figure 4) to the conduit
fitting of the control cable.
9 Push throttle actuator (1, Figure 4) to full idle travel stop
position.
10 Adjust control cable terminal to the distance "d" (refer to
Figure 4) between protective wiper seal end and the begin-
ning of the terminal thread depending on the configuration
as outlined in the following table.
n o i t a r u g i f n o C " d " e c n a t s i D
k c o l b p m a l c e r a u q s
e p y t t s u a h x e y n a d n a
) m m 1 ± ( m m 2 1
k c o l b p m a l c m i l s
t s u a h x e d r a d n a t s d n a
) m m 1 ± ( m m 4 1
k c o l b p m a l c m i l s
t s u a h x e l a n o i t p o d n a
) m m 1 ± ( m m 8
N O T E It is essential that the rod end is screwed onto the
threaded terminal until the inspection hole of the rod
end is completely filled with thread (minimum 8 turns).
11 Screw the rod end onto the threaded terminal to match the
full idle travel stop throttle actuator position. Tighten the
counternut.
12 Install rod end to throttle actuator with bolt, washers, castle
nut and cotter pin (2, Figure 4). Tighten the castle nut slightly.
Ensure movability of actuator.
Perform the following steps on the throttle control lever
side of the throttle control cable, if there are no travel stops
at the throttle control lever:
N O T E It is essential that the rod end is screwed onto the
threaded terminal until the inspection hole of the rod
end is completely filled with thread (minimum 8 turns).