Extra 300/SC, Руководство по обслуживанию

Страница: 132 / 250

CHAPTER 32
PAGE 4 PAGE DATE: 12. February 2019
MAINTENANCE MANUAL EXTRA 300/SC
32-10-01 Main Landing Gear
Removal/Installation
Refer to Figure 2
1 Remove the engine cowling, the landing gear cuffs and
fairings, and the bottom fuselage cover per Chapter 51.
2 Shore the aircraft as per Chapter 07-20-00
3 Drain brake system.
4 Unfasten the ventilation tubings and disconnect the brake
lines from the brake assembly.
5 Remove the four landing gear attachment stop nuts (LN9348-
8) (1) and the DIN 125 M8 washers.
6 Remove the bottom halves of the mounting clamps (2), the
anti abrasion strips (3) and the landing gear (4).
7 Install in reverse sequence of removal using new stop nuts.
For correct position of landing gear the mandrel, which is
located at the bottom of the fuselage, is to put into the re-
spective sleeve at the top of the landing gear spring. Re-
plenish brake fluid per Chapter 12.
32-10-02 Top Half of the Mounting Clamp
Removal/Installation
Refer to Figure 2
1 Remove the main landing gear as per Chapter 32-10-01.
2 Remove the LN9348-10 stop nuts, the DIN125 M10 wash-
ers and the LN9037-10054 bolts (5).
3 Remove the top half of the mounting clamp (6).
4 Reverse procedure for installation. Apply AeroShell Grease
22C (MIL-PRF-81322F) to the bolt (5) shaft and to the un-
derside of the bolt head and torque according to the special
torque value given in Chapter 20.