Extra 300/SC, Руководство по обслуживанию

Страница: 204 / 250

CHAPTER 73
PAGE 11
MAINTENANCE MANUAL EXTRA 300SC
PAGE DATE: 12. February 2019
1 Place throttle actuator to full idle travel stop position.
2 Check distance "d" (refer to Figure 4) between protektive
wipper seal end and the beginning of the terminal thread
depending on the configuration as outlined in the following
table. Adjust rod end if value is out of limit.
n o i t a r u g i f n o C " d " e c n a t s i D
k c o l b p m a l c e r a u q s
e p y t t s u a h x e y n a d n a
) m m 1 ± ( m m 2 1
k c o l b p m a l c m i l s
e p y t t s u a h x e y n a d n a
) m m 1 ± ( m m 8
3 Check throttle control lever is 1.5 mm from rear travel stop.
4 If it is not, adjust rear travel stop bolt by removing or adding
washer(s) and retightening.
5 Place throttle actuator to full WOT position.
6 Check throttle control lever is 1.5 mm from travel stop.
7 If it is not, adjust front travel stop bolt by removing or add-
ing washer(s)and retightening.
Procedure without throttle control lever travel stops:
Refer to Figure 4, Sheet 1 or 2 depending on the exhaust
system installed and Figure 3, Sheet 1.
1 Move the throttle control lever (4, figure 3) in full idle po-
sition (as shown in figure 3).
2 Check throttle actuator (1, figure 4) of the fuel injector servo
reached travel stop for full idle position.
3 Check distance "d" (refer to Figure 4) between protektive
wipper seal end and the beginning of the terminal thread
depending on the configuration as outlined in the following
table. Adjust rod end if value is out of limit.