Expert Electronics SunSDR2 Pro, Руководство пользователя

Страница: 94 / 95

94
SunSDR2 PRO User Manual
© 2018 Expert Electronics
TRANSCEIVER OPERATIONS
8
RESET DEFAULT SETTINGS
Sometimes you may need to reset IP address and ports of the transceiver, to do that follow the
steps below:
1. Switch off the transceiver with the PWR button;
2. Press and hold the RST button on the rear panel of the transceiver, you will hear a light click;
3. Switch on the transceiver with the PWR button. The LED will blink different colors ( green
and red );
4. Release the RST button;
5. Wait until the LED turns to constant green light, it means the reset went successfully.
After the reset procedure the transceiver will have the default IP-address 192.168.16.200 and
ports 50001, 50002.
In case there is something wrong with the device, but you cannot connect with it to figure it out,
you may try to do a “deep” reset:
1. Switch off the transceiver with the PWR button;
2. Press and hold L/W and RST buttons simultaneously;
3. Switch on the transceiver with the PWR button. The LED will blink different colors ( green
and red );
4. Release RST and L/W buttons;
5. LED will blink with green light, launch the ExpertSDR2, press the red Start button, transceiver
will update the firmware.
6. Wait until the LED turns to constant green light, it means the reset went successfully.
When the transceiver is switched on, the RST button won't be active. Pressing it doesn't have
any effect.
Warning!
Do not switch off the transceiver with the PWR button while LED is
blinking.