28
SunSDR2 PRO User Manual
© 2018 Expert Electronics
ExpertSDR2 SOFTWARE DESCRIPTION
- drop-down menu with CW settings:
Speed - the speed of the CW signal being sent.
BreakI n delay (ms) - timing control, to keep the transceiver in the TX mode. Set the required
time for the transceiver to hold in the TX mode after you let go of the CW keyer.
Pit ch (Hz) - CW signal's frequency tone control. Set the required CW signal's frequency tone
(also used for the RX mode).
Widt h (%) - Dot-to-pause ratio. Width value 50, means that Dot equals pause in length. Dash
always equals 3 Dots.
Ramp (ms) - CW signals' slope length control. Set the required CW signals' slope length. The
higher manipulation speed, the shorter should be slopes.
I ambic - enable/disable automatic dots and dashes generation. If the IAMBIC mode is off,
while you press the CW keyer it will generate tone signal with PITCH frequency.
Reverse paddle - enable the checkbox to generate dots and dashes in reverse order.
Macros Speed - speed of CW macroses generation via TCI interface.
Macros Delay - CW macroses generation delay after switch from RX to TX, via TCI interface.
When you enable the BreakIn you’ll see the following message in the Status bar:
WARNI NG ! PTT swit ching delays are disabled in CW mode, and wit h CW
manipulat ion in SSB! Be caref ul using an ext ernal PA!
- turns on the compression of the transmitted signal (COMP).
- Via the drop-down menu, you can adjust the compression and
threshold levels.
Note:
·
Set the MIC AGC gain, that the microphone signal is increased to the level of -10...-5 dB on
the MIC-meter indicator (green bar).
Содержание SunSDR2 Pro
Страница 2: ......
