Exmark QSS708GEM42200, Руководство оператора

Страница: 61 / 76

Maintenance
4. Using a spring removal tool, (P/N. 92-5771),
remove the idler spring from the deck hook to
remove tension on the idler pulley and roll the
belt off of the pulleys (Figure 75 and Figure 76).
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
G014930
1
2
3
3
4
5
1
2
3
3
4
5
6
4
Figure 75
42 Inch Decks
1. Idler pulley 4. Spring
2. Mower belt 5. Engine pulley
3. Outside pulley 6. Spring removal tool
G014931
1
2
3
3
4
5
6
Figure 76
50 Inch Decks
1. Idler pulley 4. Spring
2. Mower belt 5. Engine pulley
3. Outside pulley 6. Spring removal tool
5. Route the new belt around the engine pulley and
mower pulleys (Figure 76).
6. Using a spring removal tool, (P/N 92-5771),
install the idler spring over the deck hook and
placing tension on the idler pulley and mower belt
(Figure 75 and Figure 76).
Installing the Mower
Service Interval: As required
1. Park the machine on a level surface and disengage
the blade control switch.
2. Ensure the parking brake is engaged, stop the
engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Lift the rear of the mower deck and guide the
hanger brackets over the rear lift rod (Figure 74).
6. Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter (Figure 72).
7. Install the mower belt onto the engine pulley;
refer to Replacing the Mower Belt .
61