Page 1 of 5
109-6448 Rev. A
Loose Parts
Note:
Use the chart below to verify that all parts have been shipped.
109-5736
Dealer Pack
Part #
Description
Qty
Use
323-6
98-5975
3290-357
Cap Screw, Hex 3/8-16 x 1
Washer, Belleville
Nut, Hex Flange 3/8-16
8
8
8
Installing the Rollover Protection System (Roll Bar)
103-1309
Warranty Registration Form
1
Fill out and return to Exmark
103-2106
1-603511
Key, Exmark Ignition
Key, Standard Ignition
1
1
Unit ignition
32128-20
Nut, 5/16-18 Whizlock
4
For fastening seat tracks to unit seat frame
109-5733
Literature Pack
Part #
Description
Qty
Use
------------
------------
109-3498
Manual, Operator’s
Manual, Parts
DVD, Exmark Safety Video
1
1
1
Read and view before operating machine
109-6435 Sht,
Emissions
Warranty
1
Installing the Rollover Protection
System (Roll Bar)
1. Remove sides and top of crate from the base.
2. Remove roll bar components from the crate.
3. Remove roll bar tubes from sides of crate.
4. Remove the two brackets used to mount the
bottom of the upper roll bar tube to the crate.
5. Remove the 1/2-13 x 3 1/4 capscrews and 1/2-13
hex flange lock nuts from the two brackets at
each end of the upper roll bar tube and retain for
later use (Fig. 1).
6. Remove the (4) 1/4” lag screws holding the wheel
hub brackets to the crate bottom and discard.
7. Raise the rear of the unit approximately 10-12”
and support it with jack stands or equivalent
support.
CAUTION
POTENTIAL HAZARD
♦
Raising the rear of the unit for assembly relying
solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦
The mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
HOW TO AVOID THE HAZARD
♦
DO NOT rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands or
equivalent support.
8. Locate the left and right lower roll bar tubes.
9. Align lower roll bar tubes along rear engine frame
(Fig. 2).
10.
LOOSELY
install lower roll bar hardware (four
3/8-16 x 1 capscrews, four spring disk washers
and four 3/8-16 whizlock nuts) to the tubes on
each side. (Fig. 2).
LAZER Z
®
AS
SETUP INSTRUCTIONS
FIGURE 1
For Serial Nos. 670,000 and Higher
